Results 1 to 2 of 2

Thread: Omni Power Camber Kit Package

  1. #1

    Default Omni Power Camber Kit Package

    Omni Power Camber Kit Package $150
    Package Includes Front Camber Kit Set & Rear Camber Kit Set.



    Front Kit
    Omni-Power front camber kits are designed for vehicles that are in need of both adding and removing camber. Great care was taken to adjust the angle of the ball joint mount to allow adequate room for lowered vehicles. Omni-Power ball joints are forged steel and manufactured to precise tolerances. Our ball joints differ from other manufactures in 2 ways. 1. they have more room for travel, allowing over 10 degrees more adjustment than similar competitors, preventing ball joint binding with extreme suspension geometries. 2 they can be attached to the control arm on both the top and the bottom to offset lowered cars extreme hub angles and provide additional room between the shock tower and upper a-arm. These camber kits are currently used on many professional high profile road and drag race vehicles around the world. Each camber kit provides +-4 degrees of adjustment making them the ideal choice for any situation. Omni-Power camber kits are stamped prior to powder coating with our logo for easy distinction from other brands. For an additional $15 we can include a rear shim kit which enables you to remove up to 4 degrees of negative camber in the rear, making them a fantastic value for your hard earned dollar.



    Rear Camber Kit
    Omni-Power rear camber kits are designed for vehicles that are in need of both adding and removing camber. These camber kits are currently used on many professional high profile road and drag race vehicles around the world. Each camber kit provides + or - 5 degrees of adjustment making them the ideal choice for any situation. Omni-Power uses hard rubber bushings that will not prematurely fail and we use a forged aluminum center nut to decrease weight while maintaining sufficient strength. Each rear camber kit installs in minutes and is a direct oem replacement.
    Built By Notorious
    823 N 7th Ave
    Phoenix AZ 85007
    602-339-0308
    www.BuiltByNotorious.com
    www.BBN-Performance.com

  2. #2

    Default -

    To answer your original question of adding 94-04 LCA for extra camber, I have done that on mine. I have 99-04 LCA, but also needed clearance to fit a 315 tire on the front. I have roughly -3 on camber both sides and roughly 6 degrees of caster.

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •