PDA

View Full Version : 91 Rotor install problem



orticus
11-02-2009, 02:22 AM
Yesterday i started the task of replace both sets of brakes, New rotors, calipers, pads lines in the front. I had a hell of a time removing the hub from rotor as two of the bolts were rounded off. Got them off eventually and when i went to put the new rotor hub assembly back on it doesn't seem to fit all the way, i can see the axle and the threads for the 36mm nut but its like 1/2 in. from the end and i cant start the nut to tighten it up.

Thanks
Andrew

If needed i can post a few pics tomorrow its late and i dont think the pictures will come out well.

Matt04V6EX
11-13-2009, 03:36 AM
was your replacement stuff OEM or AEM?